Ručna hidraulična mašina za rezanje čeličnih šipki

Structure: The hydraulic system of the manual hydraulic steel bar cutting machine is composed of pistons, plungers, hydraulic cylinders, pressure rods, pull pins, return springs, oil storage barrels and discharge and suction valves. Working principle: First tighten the oil discharge valve clockwise, lift the pressure rod, the plunger is lifted, the oil suction valve is opened, and the hydraulic oil enters the oil chamber; when the pressure rod is lifted, the hydraulic oil is compressed into the cylinder cavity, thereby Push the piston forward, and the movable cutter installed at the front end of the piston can cut off the material. Immediately after the material is cut off, unscrew the oil valve counterclockwise. Under the action of the return spring, the pressure oil flows back to the oil chamber, and the cutter automatically retracts into the cylinder. And so on and so forth, to cut tendons. It is suitable for cutting all kinds of ordinary carbon steel, hot rolled round steel, rebar, flat steel and square steel in construction projects. Cutting round steel: (Q235-A) Diameter: (Φ6-Φ40) mm Cutting flat steel Maximum specification: (70x15) mm Cutting square steel: (Q235-A) Maximum specification: (32x32) mm Cutting angle maximum specification: (50x50 )mm